Asus Terminator A7VT - Manual (Page 79)

ASUS Terminator 1 A7VT barebone system 79
5.4.3 Chipset configuration
The items in this menu show the chipset configuration settings. Select an
item then press to display a pop-up menu with the configuration
options.
AGP Display Switch [Auto]
Select [Auto] to boot from the AGP card first. Select [Onchip AGP] to boot
from the Onboard VGA even if there is an AGP card.
Configuration options: [Auto] [Onchip AGP]
Init Display First [Auto]
Allows you to set which graphics controller to use as the primary boot
device. Configuration options: [PCI slot] [AGP]
AGP Bridge Configuration
This sub-menu allows you to set the values for the following items:
Graphics Aperture Size [64MB]
Allows you to select the size of mapped memory for AGP graphic
data. Configuration options: [1G] [512M] [256M] [128M] [64M] [32M]
[16M] [8M] [4M]
AGP Mode [4X]
When set to [4X], this item allows 1066 MB/s video data transfers
through the AGP 4X interface card. When set to [1X], the AGP
interface only provides a peak data throughput of 266 MB/s even if
you are using an AGP 4X card. Configuration options: [1X] [2X] [4X]
AGP Display Switch [Auto]
Init Display First [PCI slot]
AGP Bridge Configuration
Select Menu
Item Specific Help
Chipset