Asus P5QL - Manual (Page 32)

1-22 Chapter 1: Product introduction
2. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect
the S/PDIF Out module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
The S/PDIF module is purchased separately.
P5QL
SPDIF_OUT
+5
V
SPDIFOU
T
GND
P5QL Digital audio connector
3. Serial ATA connectors (7-pin SATA1-6)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.
Connect the right-angle side of SATA
signal cable to SATA device. Or you
may connect the right-angle side of
SATA cable to the onboard SATA
port to avoid mechanical conflict with
huge graphics cards.
right angle side
SATA1
GN
D
RSATA_RXN1 RSATA_RXP1 GN
D
RSATA_TXN1 RSATA_TXP1 GN
D
SATA3
GN
D
RSATA_RXN3 RSATA_RXP3 GN
D
RSATA_TXN3 RSATA_TXP3 GN
D
SATA5
GN
D
RSATA_RXN5 RSATA_RXP5 GN
D
RSATA_TXN5 RSATA_TXP5 GN
D
SATA2
GN
D
RSATA_TXN2 RSATA_TXP2
GN
D
RSATA_RXN2 RSATA_RXP2
GN
D
SATA4
GN
D
RSATA_TXN4 RSATA_TXP4
GN
D
RSATA_RXN4 RSATA_RXP4
GN
D
SATA6
GN
D
RSATA_TXN6 RSATA_TXP6
GN
D
RSATA_RXN6 RSATA_RXP6
GN
D
P5QL
P5QL SATA connectors (ICH10R ® )