Asus P5QL - Manual (Page 52)

2-14 Chapter 2: BIOS information
DRAM Static Read Control [Auto]
Adjusting this item might enhance DRAM overclocking ability.
Configuration options: [Auto] [Disabled] [Enabled]
DRAM Read Training [Auto]
Adjusting this item might enhance DRAM overclocking ability.
Configuration options: [Auto] [Disabled] [Enabled]
MEM. OC Charger [Auto]
Adjusting this item might enhance DRAM overclocking ability.
Configuration options: [Auto] [Disabled] [Enabled]
Ai Clock Twister [Auto]
Allows you to set the DRAM performance. Set this item to [Light] or [Lighter] to enhance
DRAM compatibility, or [Strong] or [Stronger] to accelerate DRAM performance.
Configuration options: [Auto] [Lighter] [Light] [Moderate] [Strong] [Stronger]
Ai Transaction Booster [Auto]
Allows you to set the system performance. Configuration options: [Auto] [Manual]
The following items appear only when you set the Ai Transaction Booster item to
[Manual].
C/P: A1 A2 A3 A4
LVL: 09 09 09 09
Common Performance Level [05]
Set this item to a higher level for better compatibility or a lower level for better
performance. Use the <+> and <-> keys to adjust the value.
Pull-In of CHA/B PH1/2/3/4 [Disabled]
Set this item to [Enabled] to apply enhancement on DRAM Channel A and B, Phase
1 to 4. The number of phases is determined by DRAM frequency and FSB strap.
Configuration options: [Disabled] [Enabled]
CPU Voltage [Auto]
Allows you to set the CPU VCore voltage. The values range from 0.8500V to 1.7500V with a
0.00625V interval. Configuration options: [Auto]
Refer to the CPU documentation before setting the CPU Vcore voltage. Setting a high
VCore voltage may damage the CPU permanently, and setting a low VCore voltage may
make the system unstable.
FSB Termination Voltage [Auto]
Allows you to set the front side bus termination voltage. The values range from 1.20V to
1.50V with a 0.10V interval.
The minimum value becomes 1.10V and the maximum value becomes 1.40V when a 45nm
CPU is detected.