Asus TS700-E6/RS8 - Manual (Page 150)

7-8 Chapter 7: Driver installation
7.1.3 Red Hat ® Enterprise Linux OS
To install the RAID controller driver when installing Red Hat ® Enterprise OS:
1. Boot the system from the Red Hat ® OS installation CD.
2. At the boot:, type linux dd, then press .
When you are installing RHEL AS5 and loading RAID driver, type after the
boot: linux dd noprobe=ata1 noprobe=ata2..... . The number
of ata varies with the hard disk drives you have when building a RAID set.
For example, if you want to build a RAID set with six hard disk drives, type
command line: linux dd noprobe=ata1 noprobe=ata2 noprobe=ata3
noprobe=ata4 noprobe=ata5 noprobe=ata6 .
- To install or upgrade in graphical mode, press the key.
- To install or upgrade in text mode.
- Use the function keys listed below for more information.
[F1-Main] [F2-Options] [F3-General] [F4-Kernel] [F5-Rescue]
boot: linux dd
3. Select Yes using the key when asked if you have the driver disk, then
press .
Driver disk
Do you have a driver disk?
Yes No
4. Insert the Red Hat ® Enterprise RAID driver disk to the floppy disk drive, select
OK, then press .
The drivers for the RAID controller are installed to the system.
Insert Driver Disk
Insert your driver disk into /dev/sda
and press “OK” to continue.
OK Back