Asus F74 - Manual (Page 44)

44 Notebook PC User’s Manual
IV
. BIOS Software
Item Specific Help
PhoenixBIOS Setup Utility
F1 Help Select Item Change Values F9 Setup Defaults
Esc Exit Select Menu Enter Select Sub-Menu F10 Save and Exit
Main Advanced Security Power Boot Exit
Set password to enable
system security
Set Password: [Enter]
Password checking: [Disabled]
Advanced Sub-Menu (Cont’)
ECP Mode: The port is both software and hardware compatible with existing parallel ports so that it may be used as a
standard printer mode if ECP is not required. ECP mode provides an automatic high burst-bandwidth channel that
supports DMA for ECP in both the forward (host to peripheral) and reverse (peripheral to host) direction.
Options in the field of Base I/O address are used to choose the I/O (port) address for the Parallel port. NOTE: This field
is only available when the Parallel port field is set to User. The available options are:
[378 / IRQ7] [378 / IRQ5] [278 / IRQ7] [278/ IRQ5]
The DMA Channel field allows you to configure the Parallel port DMA Channel for the selected ECP mode. NOTE:
This field is only available when the Parallel port field is set to User and the Mode field is set to ECP. The following
options are available:
[DMA 1] [DMA 3]
After using the legend keys to make your selections for the I/O Device Configuration sub-menu, press the [Esc]
key to exit back to the Advanced menu.
Security Menu