Asus B and W PCI CARD - Manual (Page 88)

ASUS SpaceLink B&W PCI Card 87
Chapter 5 - Troubleshooting
Chapter 5
Troubleshooting (Cont.)
Bluetooth
Cannot Connect to a Paired Device
Paired devices are always displayed in My Bluetooth Places, even if the remote
device is out of range or not powered up.
• Verify that the remote member of the pair is within radio range and
powered up and then attempt the connection again.
Cannot discover services on an unpaired remote device
The remote device may not be powered up or may be out of range.
• Verify that the remote device is powered up.
• Verify that the remote device is in Connectable mode (Bluetooth Con-
figuration Panel > Accessibility tab).
• Perform a Search for Devices to verify that the device is within range.
Cannot discover services on an unpaired remote device
The remote device may not be powered up or may be out of range.
• Verify that the remote device is powered up.
• Verify that the remote device is in Connectable mode (Bluetooth Con-
figuration Panel > Accessibility tab).
• Perform a Search for Devices to verify that the device is within range.
Dial-up Networking service does not start
The Dial-up Networking service will not start unless a properly configured
modem is attached to the server.
• Verify that the modem is usable as a local device from the server. In the
Bluetooth Configuration Panel, Local Services tab, double-click the
Dial-up Networking service: Click the down arrow in the Modem field
and select the modem that will be used to dial out | Click the OK button
| Click the OK button to close the Bluetooth Configuration Panel.
Determine the BDA of installed hardware
In the Bluetooth Configuration Panel, on the Hardware tab, in the Devices
section, select the device you want to determine the address of. In the Device