Net Optics 8x1 Regeneration Taps - Manual (Page 7)

8x1 Regeneration Taps
4
Product Diagrams
A Network A B Network B
Regen Tap
Full duplex
1000
100
10
Push to
change
mode
Mode Change Button (recessed)
16 RJ45 Monitor Ports
for 8 x 1 Regeneration
Power LEDs
2 RJ45 Network Ports Mode LEDs
Figure 1: Front panel, copper models
A Network A B Network B
Regen Tap
Network A
Network B
10 Gigabit
1 Gigabit
SX
16 SFP Monitor Ports
for 8 x 1 Regeneration
Power LEDs
LC Network Ports
Bubble Label
SX, LX, SR, LR, 50µm
Link & Speed LEDs
for Network Ports
Figure 2: Front panel, fiber models
Redundant Power Supplies
Ground Stud
Fan Fan
1 0 1 0
SERIAL
NUMBER
XXXXXX
Figure 3: Rear panel, AC models
Redundant Power Supplies
For use with -48V Only
- +
For use with -48V Only
- +
Ground Stud
Fan Fan
SERIAL
NUMBER
XXXXXX
Figure 4: Rear panel, DC models
Note: ________________________________________________________________
Each AC or DC power source should be independent of the other in order to
have power redundancy. If you do not require power redundancy, the unit can
be operated with a single power cord connected to a single AC or DC power
source. In this case, either AC or DC power connector on the rear of the unit
can be used for the connection.
______________________________________________________________________