Net Optics 8x1 Regeneration Taps - Manual (Page 10)

8x1 Regeneration Taps
7
Connecting Power
Use the following procedures to safely connect AC or DC power to the unit.
Caution: ____________________________________________________________
For AC models, use the AC power cords supplied with the product. If you
use other AC power cords, they should have a wire gauge of at least 20 and
a 230VAC 1A rating. Be sure to use a three-prong cords and connect them to
sockets with good earth grounds.
For DC models, you must supply your own power cables. DC power cables
should have a wire gauge of at least 18 and a 72VDC 2A rating. Always
connect the earth grounds first, and keep the earth grounds connected
whenever you are working on the device. When disconnecting the device from
DC power, remove the earth ground connections last.
______________________________________________________________________
To connect AC input power on AC models:
1. Connect the ground stud near the center of the rear panel to a good earth
ground. Usually this will be the same as the equipment rack ground.
2. Connect one of the AC power cords to one of the AC power connectors on
the rear panel.
3. Install a power supply clip over the head of the AC power cord to keep it
from accidently being unplugged from the AC power connector.
4. Plug the other end of the cord into an AC power source.
5. Push the "1" side of the power switch immediately above the power
connector to activate power.
6. Repeat Steps 2 to 5 for the other AC power source. Be sure to plug it into
an independent power circuit for power redundancy.