Pro Series 51075 51 Receiver - Manual

Installation Instructions
Ford F-150
Lincoln Mark LT
Part Numbers:
51075
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 3/4”, 7/8”, 21mm
Drill Bits: None
1. Raise hitch into position as shown in Figure 1.
2. If the small brackets on the hitch do not go between the ends of the saddle bracket on the vehicle’s bumper, the bumper may be
loosened and recentered. After adjustment, tighten the M14 OE flange nuts to 148 lb-ft (201 N-m). See Figure 2.
3. Install all fasteners as shown. Make sure that spacers are placed between the back of the frame and the hitch.
Rev. A 10-9-07 51075N Sheet 1 of 3 z 2007 Cequent Towing Products
Nut, 1/2” Qty. (6) 3
Spacer, 1/4” x 1” x 2” Qty. (2) 5 Conical Washer, 1/2” Qty. (12) 2
Hex Bolt, 1/2”-13 x 2” Qty. (4) 4 Hex Bolt, 1/2”-13 x 1-1/2” Qty. (2) 1
Tighten all 1/2” GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 51075F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
600 lb (272 kg) 6,000 lb (2,724 kg)
Weight Carrying
Ball Mount
1,000 lb (454 kg) 10,000 lb (4,540 kg) Weight Distributing
Max Tongue
WT
Max Gross
Trailer WT
Hitch type
Wiring Access Location: PU3
Bumper
Fascia
Frame
FIGURE 1
Frame Rail
Saddle Bracket
Bumper
OE Nuts
FIGURE 2
ALL FASTENERS TYPICAL
BOTH SIDES