Pro Series 97094 51 Receiver - Manual

Installation Instructions Part Numbers:
51094
97094
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 3/4”
Drill Bits: NONE`
1. IF PRESENT, LOWER CARBON CANISTER FROM DRIVER’S SIDE FRAME RAIL.
2. INSTALL FORWARD AND REARWARD CARRIAGE BOLTS AND BLOCK IN FRAME RAILS AS SHOWN.
3. RAISE HITCH INTO POSITION AND HAND TIGHTEN FORWARD AND REARWARD FASTENERS TO BOTH RAILS AS
SHOWN.
4. INSTALL CENTER CARRIAGE BOLT AND BLOCK IN FRAME PLACING FLAT WASHER BETWEEN RAIL AND HITCH AS
SHOWN. (DO NOT OVERLAP BLOCKS)
5. REATTACH CARBON CANISTER IF PRESENT – CARBON CANISTER MUST NOT CONTACT BOLT HEAD, IF IT DOES,
LOOSEN CANISTER FASTENERS AND REPOSITION TO ENSURE CLEARANCE WITH BOLT HEADS.
z 2008, 2012 Cequent Towing Products
Sheet 1 of 3 51094N 2-1-12 Rev. B
j
Qty. (6) CARRIAGE BOLT 1/2-13 X 2.00 GR 5
m
Qty. (6) HEX NUT 1/2-13
k
Qty. (8) FLAT WASHER 1/2
n
Qty. (6) BLOCK 1/4 x 1.500 x 2
l
Qty. (6) LOCK WASHER 1/2
Tighten all 1/2 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 51094F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 8,000 (3632 Kg) 800 (363 Kg)
Weight Carrying
Ball Mount
6,000 (2724 Kg) 600 (272 Kg)
Wiring Access Location: SUV1, SUV2
STEP BUMPER
STANDARD
BUMPER
FRAME RAIL
FLAT WASHER
FORD ECONOLINE VAN
E-150, E-250 & E-350