Pro Series 63156 ROOF TOP CARRIER - Manual (Page 2)

Item:
Description:
Cequent Performance Products, Inc.
47912 Halyard Drive, Suite 100
Plymouth, MI 48170
63156N Rev C 9-13-12
Printed in China
63156
Big Sky™ Rooftop Cargo
Basket
Page 2 of 15
STEP 1 STEP 1 STEP 1 STEP 1
• Unpack cargo basket.
• Remove hardware and protective
cover off air deflector.
• Read and follow all instructions.
STEP 2 STEP 2 STEP 2 STEP 2
ASSEMBLE CARGO BASKET
• To assemble the cargo basket, place
the 3 panels of the basket on a flat
non-marring surface.
• Apply a small amount of rubber safe
lubricant on the inside of all 8
gaskets.
• Slide the gaskets on the ends of the
front and rear sections, about 1” from
the end.
• Line up the holes of the mid section
with the holes in the front and rear
sections.
• Secure the tube with the 8 washers
and self tapping screws.
• Once completed, basket should look
like Figure 1.
Line Up
Holes
SELF TAPPING
SCREW & WASHERS
(8) PLACES
FRONT SECTION
MID SECTION
REAR SECTION
GASKETS
STEP 3 STEP 3 STEP 3 STEP 3
ATTACH AIR DEFLECTOR
• Line up the holes in the air deflector with the four holes in the front cross tubes of the cargo
basket. Install four #8 self tapping screws and rubber washers as shown. Tighten screws until
the rubber washers start to compress – DO NOT OVER TIGHTEN!!
Over tightening of screws
could cause the deflector to crack. DO NOT PEEL OFF FOAM GASKETS ON BACK OF
DEFLECTOR.
RUBBER WASHER
NO. 8 SCREWS
FIGURE. 1
TOOLS USED:
PHILLIPS
SCREWDRIVER
TOOLS USED:
PHILLIPS SCREWDRIVER &
LUBRICANT