OSRAM Touch DIM RC - Manual

Page 1 of 2
Radio receiver module
Fitting instructions
TOUCH DIM RC
Description
Purpose and application
The TOUCH DIM RC radio receiver module enables the
wireless control of two luminaire groups, each with up to 15
electronic control gears featuring the TOUCH DIM ® function.
The radio receiver can be installed in luminaires or, with the op-
tional cable strain relief kit LMS CI BOX, in suspended ceilings.
Function
The radio receiver converts the radio signals from TOUCH
DIM WCU wall transmitters or TOUCH DIM RMC hand-held
transmitters to TOUCH DIM signals and transmits these to the
connected electronic control gears.
Design
The radio receiver is made up of the following components:
• Connections (A):
– L, N: power supply
– Ch 1, Ch 2: floating outputs,
e.g. for connecting electronic control gear (channels 1
and 2)
– Learn: optional pushbutton input for training and
untraining wall-mounted/hand-held transmitters
– T1, T2: optional pushbutton inputs for control via a cable
• „Press to activate learn mode“ button for training/untraining
wall-mounted/hand-held transmitters (B)
• LED (C)
Installation
Safety instructions
The radio receiver must only be installed and put into operation
by a qualified electrician. The applicable safety regulations and
accident prevention regulations must be observed.
WARNING!
Exposed, live cables.
Danger of electric shock!
• Only work on the radio receiver if it has been
de-energised.
CAUTION!
Destruction of the radio receiver and other devices
due to incorrect installation!
• Adhere to the connection diagram.
• Do not exceed the maximum number of electro-
nic control gears.
• Only use OSRAM electronic control gear or
transformers with the TOUCH DIM function.
• Only supply the radio receiver with an AC
operating voltage, especially in networks with
UPS systems.
• Do not wire pushbutton inputs (learn, T1, T2)
with an external voltage, especially not a mains
voltage of 230 V.
Selecting the installation location
Observe the guide values for the radio transmission ranges
when selecting an installation location; see „Technical data“. If
necessary, perform a range test before installing the unit.
The radio transmission range between the wall-mounted/hand-
held transmitter and radio receiver is influenced by the following
factors:
• Construction materials
• Type and number of obstacles between the transmitter and
receiver
• Sources of interference and signal reflections
Connecting the radio receiver
D Luminaire group on channel 1 (Ch 1)
E Luminaire group on channel 2 (Ch 2)
TOUCH DIM RC L Learn
T1
T2
Ch1 out
Ch2
out
N A
C
B
A
D
E
N
L
PE
DA
DA
DALI EVG
N
L
PE
DA
DA
DALI EVG
N
L
PE
DA
DA
DALI EVG
TOUCH DIM RC
L
N
Ch1
Ch2
Learn
T1
T2
L N PE
DALI EVG N
L
PE
DA
DA