OSRAM Touch DIM LS LI - Manual (Page 2)

80° – 100° 80° – 100°
H
I
K
OSRAM GmbH
Kunden Service Center
Customer-Service-Center (CSC)
Steinerne Furt 62
86167 Augsburg
Germany
Tel : +49 (0) 1803 677 - 200
(kostenpflichtig / charges apply)
Fax.: +49 (0) 1803 677 - 202
www.osram.com
www.osram.de
40083210230878
4008321023087
Fitting (cont.)
IX 2008
TouchDIM-LS-LI_ma0809en_we1.02.indd
Selecting the installation location
H Surveillance cone: entire workplace; not on window surfaces
I Avoid direct light irradiation
K Place centrally.
80° – 100°
Touch DIM Sensor
Optimum installation location
80° – 100°
Touch DIM Sensor
Possible installation location
Appendix
Technical data
Operating voltage 220-240 V / 50-60 Hz (no DC
operation)
Connections L, N, S (signal)
Interface Osram-specific, maximum 4 QTi
DALI coil ballast or 4 HTi transfor-
mers or 4 OTi LED dimmers can be
connected
Maximum overall length
of the signal line
10 m
Power consumption approx. 0.5 W
Operating temperature 0 °C ... +50 °C
Adjustable light value approx. 0-300 lx measured on the
sensor (corresponds to approx.
10-1200 lx on the work surface)
Pollution severity 2 (dry, not conductive to IEC 664)
Dimensions 63 x 29 x 21 mm
(L x W x H)
Protection class II
Protection type IP 20
The EMC requirements to EN 61547 are fulfilled.
Conformity with the relevant EU directives is
confirmed by the CE symbol.