Operation, Appendix – OSRAM EASY RMC User Manual
Page 2
Page 2 of 2
Operation
Note
For the function of the DALI EASY III and OT EASY 60 II control
units, see the separate instructions.
DIP switch positions
The following settings can be made using the DIP switches (E):
DIP switch
Function
1
OFF
IR coding 1 is active
1
ON
IR coding 2 is active
2
OFF
Scene storage is disabled
2
ON
Scene storage is enabled
3
OFF
Sequence mode is disabled
3
ON
Sequence mode is enabled
4
OFF
Daylight simulation is disabled
4
ON
Daylight simulation is enabled
3/4 ON/ON
Learn mode for transmitting the
IR coding and resetting the con-
trol units to the factory settings
(RESET)
Setting the infrared coding / RESET
The two infrared codings make it possible to operate two
separate lighting control units in one room using a single remote
control without mutual interference. The control unit is returned
to the factory setting by means of a RESET or by changing the
infrared coding.
Disconnect control units whose infrared coding should not
be reset or adjusted from the mains supply or interrupt the
connection to the IR receiver.
Set the desired infrared coding via the DIP switch of the
remote control:
–
DIP switch 1 = OFF:
infrared coding 1 is active
–
DIP switch 1 = ON:
infrared coding 2 is active
Note the positions of DIP switches 3 and 4.
Set DIP switches 3 and 4 to ON.
Point the remote control to the infrared receiver and press
any button.
Confirmation:
„LS“ appears in the display and the luminaires flash.
– 1x for infrared coding 1
– 2x for infrared coding 2
Set DIP switches 3 and 4 to the original positions, reconnect
all control units to the mains supply and reconnect the IR
receiver.
Appendix
Technical data
Power supply
2 Micro AAA / LR03 batteries (alkaline)
Infrared signal
Interference-immune 38 kHz Rmap pro-
tocol, digital coded. 2 OSRAM-specific
codings are selectable.
Range
Approx. 10 – 15 m
Operating
temperature
0 °C ... +40 °C
Protection type
IP 20
Dimensions
(L x W x H)
120 x 57 x 26 mm
Conformity with the relevant EU directives is
confirmed by the CE symbol.