OSRAM LS__PD MULTI 3 A - Manual (Page 2)

Page 2 of 2
Installation (cont.)
Selecting the installation location
H Monitoring cone: entire workplace; not on window surfaces.
I Avoid exposure to direct light.
K Avoid drafts (e.g. from ventilators or fans).
L Mounting distance = min. mounting height
Mounting options
The sensor is suitable for installation in luminaires and for
retrofitting existing luminaires.
When retrofitted, the sensor is attached to the luminaire by
means of the included retaining clip (ideal for T5/T8 louver
luminaires).
80° 80°
H
I
K
L
> h
h
Appendix
Technical data
Combined control and
supply connection
4-pin modular connection
(4p4c)
1: Supply voltage
2: Light measurement value
3: Motion signal
4: Signal ground
Length 2.1 m
Maximum total length of
signal line (incl. all connec-
tions to the control units)
See control unit
Insulation Basic insulation as per IEC 664
Dimensions
(L x W x I)
37.70 x 20 x 22.20 mm
Light sensor detection area 20 – 600 lx (measured at
sensor),
opening angle approx. 90°
Motion detection area Conical,
opening angle approx. 80°
Mounting height 2 – 4 m
22,20
3
37,70
20
The CE requirements to EN 60928 are fulfilled.
The EMC requirements to EN 61547 are fulfilled.
Conformity with the relevant EU directives is
confirmed by the CE symbol.