OSRAM Touch DIM RMC - Manual (Page 2)

Page 2 of 2
OSRAM GmbH
Kunden Service Center
Customer-Service-Center (CSC)
Steinerne Furt 62
86167 Augsburg
Germany
Tel : +49 (0) 1803 677 - 200
(kostenpflichtig / charges apply)
Fax.: +49 (0) 1803 677 - 202
www.osram.com
www.osram.de
40083211830336
4008321183033
IV 2009
Touch-DIM-RMC_ba0904en_we1.01.indd
Operation (cont.)
82
m
m
20
m
m
49 mm
Conformity with the relevant EU directives is
confirmed by the CE symbol.
Appendix
Technical data
Transmission
power
10 mW
Operating
temperature
-20 °C ... +50 °C
Frequency
band
868.3 MHz
Switching
cycles
> 50,000
Functional
range
In the open air: Approx. 300 m
Halls: Approx 100 m
Passageways and corridors: Approx. 50 m
Rooms with wooden or plasterboard walls:
Approx. 30 m (max. 7 walls)
Rooms with brick or autoclaved aerated
concrete walls:
Approx. 20 m (max. 3 walls)
Rooms with reinforced concrete walls:
Approx. 10 m (max. 1 wall)
Protection
type
IP 20
Weight Approx. 46 g
Dimensions
(L x W x H)
82 x 49 x 20 mm
Troubleshooting
If you cannot remedy the fault, please contact the Customer
Service department of the luminaire manufacturer.
Luminaire does not function
No mains voltage present.
à Use a voltage tester to test if mains voltage is present.
Illuminants are faulty.
à Replace illuminant.
Luminaire was switched off via the wall-mounted or hand-held
transmitter.
à Switch on luminaire.
Luminaire does not react as expected to the press of a
button.
Hand-held transmitter has not been trained.
à Train the hand-held transmitter.
Radio receiver is too far away from the hand-held transmitter.
à Reduce the distance between the hand-held transmitter and
the radio receiver.
Button on the hand-held transmitter was pressed too long or
too short.
à See „Changing the brightness manually“.
Dimensioned drawing