OSRAM EASY PB Coupler - Manual (Page 2)

Page 2 of 2
Operation (cont.) Pure sequence mode operation
Short or long press: The corresponding sequence is started or
stopped.
On
T 1...4 Start sequence mode with sequence A..D
T 5 All luminaires: change brightness manually/switch
on and off
T 6 Resume paused sequence
T 7 Pause running sequence
T 8 Call up the next lighting scene
Light scenes and sequence mode operation
On
T 1...4 Store and call up lighting scenes 1...4
T 5 All luminaires: change brightness manually/switch
on and off
T 6 Start sequence mode with sequence A/resume
paused sequence
T 7 Pause running sequence
T 8 Call up the next lighting scene
Operation via switches or motion detector
Lighting scene operation
Close switch contact:
lighting scenes 1...15 are called up (depending on the DIP
switch setting).
Open switch contact:
lighting scene 16 is called up (default setting: all luminaires off).
For the unit to function effectively, only one of the contacts on
inputs T1 to T8 may be switched at any one time.
Push-
button
On On
T 1...7 Store and call up ligh-
ting scenes 1...7
Store and call up ligh-
ting scenes 9...15
T 8 Call up lighting scene 8 –
Sequence mode operation
Close switch contact:
sequence A..D is started
Open switch contact:
lighting scene 16 is called up (default setting: all luminaires off).
Push-
button
On
T 1...4 Start sequence mode with sequence A..D
T 5...8 –
Appendix
Technical data
Outputs EASY signal, 4-pin, SELV
• Max. 50 m line length to the next
control unit
• Max. 100 m total line length
Inputs 8 inputs for potential-free closer
contacts,max. 25 m line length at one
input,max. 50 m total line length over
all inputs
Leads diameter 0.25 …1.5 mm²
Operating tempe-
rature
0 °C …+ 50 °C
Protection type IP 20
Protection class III
Dimensions
(L x W x H)
47 x 44 x 13 mm
LED message Communication: LED flashes The CE requirements are fulfilled: EMC requirements as per
EN 61547, low voltage as per EN 60928.
Conformity with the relevant EU directives is
confirmed by the CE symbol.