OSRAM HF LS LI - Manual (Page 12)

12
3.3 Setting vibration sensitivity
Set vibration sensitivity to avoid erroneous triggering caused by vibration:
1.
Press the [PROG] button (VLP) to start programming mode.
2. Press (SP) the button [2] (inner ring segment on the remote control) to select configuration
of vibration sensitivity.
3. Set vibration sensitivity (see table) by pressing (SP) buttons [15] to [20].
4. Exit programming mode by pressing (SP) the [PROG] button or exit automatically 60 sec-
onds after the last detected movement.
Vibration sensitivity Button event
Vibration detection off Press button [20] (SP)
Min Press button [15] (SP)
Mean (works setting) Press button [16] (SP)
High Press button [17] (SP)
Very high Press button [18] (SP)
Max Press button [19] (SP)
Table: Vibration sensitivity settings
Important note:
After installation or after modifying the position/realigning of the sensor, setting vibration sensitiv-
ity is mandatory before normal motion detection is active.
3.4 Sensor LED signals
LED display (red / green),  4 (3):
LED signal Meaning
Green LED flashes Motion detected
Green LED illuminates continuously Holiday mode active (motion detection
temporarily deactivated)
Red LED flashes 3 times IR signal of remote control received
Red LED flashes 1 time Vibration detected*
Red LED illuminates continuously 100h burn-in active
Table: LED signals
3.5 Configuration of DALIeco control unit
 separate instructions
4 Accessories
 1b
(1) 4p4c connecting cables,
pre-assembled connecting cable, (50 pc. pack)
0.25 m: 4008321660145 0.5 m: 4008321660152
1.0 m: 4008321660169 2.0 m: 4008321660190
(2) DALIeco control,
2-ch. DALI control unit for installing in luminaire and ceiling, 4008321988645
(3) User remote,
user remote control, 4008321826435
(4) Master remote
Configuration remote control, 4008321988669