SENA Serial_IPTM Redirector 4.3 - Manual (Page 50)

Appendix A: Advanced Settings
A.2.1 Introduction A.2.7 Configuring the Authentication Feature
A.2.2 Security Issues in Tactical Software Products A.2.8 Configuring the Certificate Feature
A.2.3 SSL/TLS Security Features A.2.9 Troubleshooting
A.2.4 What You Need to Get Started A.2.10 COM/IP AT Commands
A.2.5 Enabling SSL/TLS Security Features A.2.11 Certificate Authorities
A.2.6 Configuring the Encryption Feature
A.2.4 What You Need to Get Started
Before you use the SSL/TLS Security features, you will need the following:
1. Administrator privileges if the Tactical Software product you are using was installed in "Administrator-
Only Mode".
2. A Tactical Software product license key that enables the SSL/TLS Security features.
Note: Unless otherwise arranged with the supplier of the Tactical Software product, evaluation licenses
do not enable the SSL/TLS Security features.
3. Optionally, a certificate authority file if you use the Authentication feature and will not use the built-in
certificate authority file that is provided with the Tactical Software product.
4. A certificate file if you are going to use the Certificate feature in an actual application.
A.2. SSL/TLS Security