What you need to get started, 2 what you need to get started – SENA Serial_IPTM Redirector 4.3 User Manual
Page 5
1.1
1.2 What You Need to Get Started
1.3
1.2 What You Need to Get Started
Before you install and use the Serial/IP Redirector, you will need the following:
1. Administrator privileges when you are installing the software.
2. A serial server on your TCP/IP local area network. This server must be configured to provide serial ports
to the network using the instructions provided by the manufacturer. Chapter 2 of this document provides
general guidance on server configuration and what to look for in the manufacturer's instructions.
3. The Serial/IP Redirector setup program. This software will be installed on each PC that uses the serial
server.
4. A license key to enable the Serial/IP Redirector software. If you are installing the 30-day evaluation
software, you don't need a license key because it is built in to the evaluation software. Exception: You do
not need a license key if a permanent license for the Serial/IP Redirector software was included with your
serial server.
1. Getting Started