Ocean Optics Remora - Manual (Page 11)

027-10000-000-02-0809 5
Chapter 2
Installing Remora
Overview
Installing the Remora consists of the following main steps:
 Configuring your computer to work with Remora
 Configuring the Remora
 Connecting Remora to your spectrometer
Configuring Your Computer
Remora can communicate over wireless (Wi-Fi) or wired Ethernet. To set up the Remora for your local
network, you need to access the Remora’s web interface through the factory-default IP address of
192.168.7.5. The Remora will always be accessible through this IP address and it cannot be changed, so if
you ever configure the Remora in such a way that it is not operating correctly, you can go back and try
again by using this web interface.
To access the Network Configuration web page on the Remora, you must first temporarily set up your
computer to use the same subnet as the Remora. The instructions for how to do this differ depending on
the operating system:
 Windows XP
 Windows Vista
 Mac OS X
 Linux
Windows XP
For computers using a Windows XP operating system, use the following procedure.
► Procedure
1. Unplug the network cable from your computer.
2. Access the Windows Control Panel.