Littelfuse Battrax Series MS-013 Positive_Negative - Manual

SIDACtor ® Protection Thyristors
122
Revised: February 22, 2011
© 2011 Littelfuse, Inc.
Specifications are subject to change without notice.
Please refer to www.littelfuse.com for current information.
SLIC Protection
Battrax ® Single Port Positive/Negative - MS-013
(T) 1
(-V
REF
) 2
(R) 3
6 (Ground)
4 (Ground)
5 (+V
REF
)
Electrical Characteristics
Description
Features and Benefits
t Low voltage overshoot
t Low on-state voltage
t Does not degrade with
use
t Fails short circuit when
surged in excess of
ratings
t Low Capacitance
t Positive and negative
ringing compatible
t Single-port protect
t Gate trgger tracking
device
Agency Approvals
Agency Agency File Number
E133083
Schematic Symbol
Pinout Designation
1
2
3
6
5
4
Part Number Marking
V
DRM
@l
DRM
=5μA
V
S
@100V/μs
I
H
I
S
I
T
V
T
@I
T
=2.2 Amps
Capacitance*
V min V max mA min mA max A max V max pF min pF max
B3104UCLxx B3104UC I±V
REF
**œ7* I±V
REF
**œ7* 100 100 2.2 4 30 200
B3164UCLxx B3164UC I±V
REF
**œ7* I±V
REF
**œ7* 160 100 2.2 4 30 200
B3204UCLxx B3204UC I±V
REF
**œ7* I±V
REF
**œ7* 200 100 2.2 4 30 200
Applicable Global Standards
t TIA-968-A
t TIA-968-B
t ITU K.20/21 Enhanced
Level
t ITU K.20/21 Basic Level
t GR 1089 Inter-building
t GR 1089 Intra-building
t IEC 61000-4-5
t YD/T 1082
t YD/T 993
t YD/T 950
The Single Port Positive/Negative Battrax Series are
programmable SIDACtor
® devices designed to protect
SLICs (Subscriber Line Interface Circuit) from damaging
overvoltage transients.
This series is designed specifically to protect SLIC devices
utilizing positive and negative ringing signals. This one
device will protect a single port.
Notes:
- Absolute maximum ratings measured at T
A
= 25ºC (unless otherwise noted).
- Devices are bi-directional
- All electrical characteristics shown are defined from Tip (pin 1) to Ground (pin 4 & 6) and
Ring (pin 3) to Ground (pin 4 & 6)
- V
REF
Max Value for the negative Battrax is -200 V.
- V
REF
.BY7BMVFGPSUIFQPTJUJWF#BUUSBYJT7
- XX = Part Number Suffix: ‘TP’ (Tube Pack) or ‘RP’ (Reel Pack).
* Off-state capacitance (C
O
) is measured across pins 1 & 4,6 and 3 & 4,6
at 1 MHz with a 2V bias.