Littelfuse SP6001 Series - Manual (Page 2)

©2012 Littelfuse, Inc.
Specifications are subject to change without notice.
Please refer to www.littelfuse.com/SPA for current information.
170
TVS Diode Arrays
(SPA ™ Family of Products)
Revision: March 20, 2012
SP6001 Series
ESD and EMI Filter Devices - SP6001 Series
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause
permanent damage to the device. This is a stress only rating and operation of the device
at these or any other conditions above those indicated in the operational sections of this
specification is not implied.
Absolute Maximum Ratings
Symbol Parameter Value Units
T
OP
Operating Temperature -40 to 85 °C
T
STOR
Storage Temperature -60 to 150 °C
Thermal Information
Parameter Rating Units
Storage Temperature Range -65 to 150 °C
Maximum Junction Temperature 150 °C
Maximum Lead Temperature
(Soldering 20-40s) 260 °C
Electrical Characteristics (T
OP
=25ºC)
Parameter Symbol Test Conditions Min Typ Max Units
Reverse Standoff Voltage V
RWM
6.0 V
Breakdown Voltage V
BR
I
R
=1mA 7.0 (90%TYP) 7.8 8.5 (109%TYP) V
Reverse Leakage Current I
LEAK
V
RWM
=5V 0.1 1.0 μA
Resistance R
A
I
R
=10mA 85 (85%TYP) 100 115 (115% TYP) Ω
Diode Capacitance 1,2 C
D
V
R
=2.5V,f=1MHz 12 pF
Line Capacitance 1,2 C
L
V
R
=2.5V,f=1MHz 19 (79.2%TYP) 24 29 (120.8%TYP) pF
ESD Withstand Voltage 1 V
ESD
IEC61000-4-2 (Contact Discharge) ±30 kV
IEC61000-4-2 (Air Discharge) ±30 kV
Cutoff Frequency 3 F
-3dB
Above this frequency, appreciable
attenutation occurs
115 MHz
Notes: 1 Parameter is guaranteed by design and/or device characterization.
2 Total line capacitance is two times the diode capacitance (C
D
).
3 50Ω source and 50Ω load termination
Analog Crosstalk (S41) Insertion Loss (S21)
3.000 000MHz Stop 6 000.000.000MHz
x2
Start
21 log MAG 5 dB/ REF 0 dB 1 _:-5.8807 dB
CH1 S
Cor
Smo
1
START 3.000 000 MHz Stop 6 000.000 000 MHz
x2
CH1 S
log MAG 10 dB/ REF 0 dB
Smo
Cor
Del
1
Product Characteristics
Lead Plating Pre-Plated Frame
Lead Material Copper Alloy
Lead Coplanarity 0.0004 inches (0.102mm)
Substitute Material Silicon
Body Material Molded Epoxy
Flammability UL 94 V-0
Notes :
1. All dimensions are in millimeters
2. Dimensions include solder plating.
3. Dimensions are exclusive of mold flash & metal burr.
4. Blo is facing up for mold and facing down for trim/form, i.e. reverse trim/form.
5. Package surface matte finish VDI 11-13.