Derale Performance 14" High Output Single RAD Pusher_Puller Fan with Premium Mount Kit - Manual (Page 2)

Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
Mount ‘C’ or ‘D’
M6 x 15
Socket
Screw
Splined
Ratchet
Brackets
M6 Square
Mount Nuts
M6 x 35
Socket
Screw
Rubber
Isolator
M6 Flat
Washer
M6 Hex
Lock Nut
Radiator Top
Mount ‘D’
Using a 2nd optional
splined ratchet bracket,
plus rubber isolator, bolt
to top of radiator.
Mount ‘C’
Using a 2nd optional
splined ratchet bracket, ,
bolt to top of radiator.
Two fans can be mounted side by side
to provide a larger cooling area.
Order an extra fan: Part No. 162XX Series
and Dual Mount Kit: Part No. 16200
See reverse for detail on mounting
diagrams and wiring instructions
Wiring
Derale has taken it to the next level with our High Output Electric Fans, using a two speed motor which allows you to activate
the Low speed function and the High speed functions at different times. Fan efficiency is optimized to give you what you
need, when you need it.
To determine which option is best for your specific application, consult a professional or go to: derale.com for wiring options.
We recommend using the proper automotive thermostats to activate Low speed at a predetermined temperature and to
activate the High speed at a second predetermined temperature.
Connect the BLACK wire to a good chassis ground. Connect the GRAY wire (low speed)
to a 12 volt SW ITCHED* positive feed. Connect the BROWN wire (high speed) to a 12 volt
SW ITCHED* positive feed.
High speed function will not operate unless low speed is activated before or
at the same time.
Connect the BLACK wire to a good chassis ground. Connect the GRAY wire (low speed) to
a 12 volt SW ITCHED* positive feed.
*SWITCHED means using an automotive rated thermostat or toggle switch.
Go to: www.derale.com for thermostat and wiring options.
NOTE: all 12 volt positive feeds should be fused with the appropriate fuse. Always use
relays of the correct rating to reduce current draw and wire overload.
When wiring into a circuit using a thermostat to control the fan operation, follow the thermostat manufacturer’s instructions.
Wiring for use with both High and Low Speeds
IMPORTANT:
Wiring for Low Speed ONLY