Sena Bluetooth SPH10H-FM v4.3 User's Guide - Manual (Page 24)

English
SPH10H-FM
23
- For some older mobile phones which do not
automatically transfer calls to the headset, press
the Phone Button after entering phone numbers on
the mobile phone keypad.
- Tap the Phone Button in stand-by mode to activate
the voice dialing of your mobile phone. For this,
the voice dialing feature must be available on the
mobile phone. Refer to your mobile phone manual
for further instruction.
Note:
1. If you are using multipoint mobile phone connection and you have
an incoming call from the second phone during the call of the first
phone, then you may still receive the call from second phone. In this
case, the call from the first phone is on waiting mode. If you end a
call, then it will automatically guide you to the first phone call.
2. If you are using multipoint connection of mobile phone and GPS, you
may not listen to the GPS voice instruction during the phone call.
12.2 Speed Dialing
You can quickly make a phone call by using the voice
speed dial menu.
1. To enter into the voice speed dial menu, double
tap the Phone Button and you will hear a mid-tone
single beep and a voice prompt saying “Speed
dial”.
2. Rotate the Jog Dial clockwise or counter-clockwise
to navigate between the menus. You will hear
voice prompts for each menu items.
3. Tap the Phone Button or the Jog Dial to select a
voice menu among the followings:
(1) Last number redial (4) Speed dial 3
(2) Speed dial 1 (5) Cancel
(3) Speed dial 2
4. After selecting the last number redial menu, you
will hear a voice prompt saying “Last number
redial”. Then, to redial the last phone call number,
tap the Phone Button or the Jog Dial.
5. To call one of the speed dials, rotate the Jog
Dial clockwise or counter-clockwise to navigate
between the menus until you hear a voice prompt
saying “Speed dial (#)”. Then, tap the Phone
Button or the Jog Dial.