Sena Bluetooth SPH10H-FM v4.3 User's Guide - Manual (Page 14)

English
SPH10H-FM
13
6.5 Pairing with the Sena SR10, Bluetooth
Two-way Radio Adapter
The Sena SR10 is a Bluetooth two-way radio adapter
for group communication, and uses HFP as do most
motorcycle specific GPS navigation systems. If you
pair the SPH10H-FM with a SR10 by multipoint pairing,
the SPH10H-FM is able to have two HFP devices at the
same time: mobile phone and Sena SR10.
1. Turn on the headset and press the Jog Dial for 5
seconds until the red LED is rapidly flashing and you
hear multiple beeps.
2. Within 2 seconds, tap the Phone Button again, then
the LED turns to blue flashing and the beeps turn to
high tone double beeps. You will hear a voice prompt
saying “Multipoint pairing”.
3. Turn on the SR10 and follow the SR10’s “Bluetooth
Headset Pairing” procedure to complete the process.
Please refer to the SR10 user's guide for details.
4. When the pairing is completed, you will hear a voice
prompt saying “Your headset is paired”.
5. If the pairing process is not completed within three
minutes, the SPH10H-FM will return to stand-by
mode.
The incoming audio from the two-way radio via SR10
is heard in the background while having an intercom
conversation or a mobile phone call. You can listen
to music, answer a mobile call, have an intercom
conversation and use a two-way radio via SR10 for
group communication as shown in the figure below.
A GPS navigation or a radar detector which has
headphone jack or audio line-out could be connected
to the SR10 by wire. The GPS voice instruction or the
radar detector alarm is also heard in the background
via SR10 while having an intercom conversation or a
phone call. Please refer to the SR10 user's guide for
details.