Sena Bluetooth SPH10H-FM v4.3 User's Guide - Manual (Page 20)

English
SPH10H-FM
19
If this feature is enabled, you can initiate an intercom
conversation with the last connected intercom friend
by speaking any word loudly enough.The most
effortless way to trigger intercom VOX is to blow into
the microphone as if blowing dust off the microphone.
If you start an intercom conversation by VOX, the
intercom terminates automatically when you and your
intercom friend remain silent for 20 seconds. However,
if you manually start an intercom conversation by
tapping the Jog Dial, you have to terminate the intercom
conversation manually.
However, even when this feature is enabled, if you
terminate intercom conversation manually with the
Jog Dial, you are not able to start intercom by voice
temporarily. In this case, you have to tap the Jog Dial
to restart the intercom. This is to prevent repeated
unintentional intercom connections by strong wind
noise. If you tap the Jog Dial to start an intercom
conversation, it is not terminated by 20 seconds of
silence. After turning SPH10H-FM off and on, you can
start intercom by voice again. 9.4 Enabling/Disabling Voice Prompts
Voice Prompt “Voice prompt”
Factory Default Enable
Enable Tap the Phone Button
Disable Tap the Jog Dial
You can disable voice prompts by configuration setting,
but the following voice prompts are always on.
- Voice prompts for configuration setting menu
- Voice prompts for battery level Indicator
- Voice prompts for factory reset
9.5 RDS AF setting (Radio Data System: Alternative
Frequencies) (Factory Default: Disabled)
Voice Prompt “RDS AF setting”
Factory Default Disable
Enable Tap the Phone Button
Disable Tap the Jog Dial
RDS AF allows a receiver to re-tune to a different frequency
providing the same station has an additional frequency. In
RDS AF, the receiver will “re-tune” to the second frequency
location when the first signal becomes too weak. With
RDS AF enabled on the receiver, a radio station with more
than one frequency can be used.