Ingalls 35120 User Manual
Ingalls For the car
Instructions for GM E-Body cars & S-10 Blazers and pickups.
Installation Location: Upper control arm mounting bolts.
Installation note: Replace one cam bolt assembly of each
control arm at a time.The opposite cam in that control arm should
be left tight.
1.
Check & document initial alignment readings.
2.
Raise vehicle underneath lower control arm.
3.
Remove wheel.
4.
Remove mounting bolt from upper shock mount, lower the
shock for clearance.
5.
Replace cam bolts as follows:
A.
Mark position of cam.
B.
Remove nut, washer and cam bolt.
C. Install lock washer & nut and tighten.
6.
Repeat step 5 for the other cam assemblies.
7.
Reinstall upper shock mount bolt and tighten.
8.
Replace wheel and proceed with alignment.
Copyright © 1999-04 Ingalls Engineering Co., Inc.
ING3512-080299
- 40000 Series (1 page)
- 93037 (3 pages)
- 93300 (2 pages)
- 93043 (3 pages)
- 39209 (2 pages)
- 35220 (1 page)
- 38930 (1 page)
- 93180-93181 (3 pages)
- 26128 (1 page)
- 93184 (2 pages)
- IK500033RDX (1 page)
- 35590-35622 (1 page)
- 35150 (1 page)
- 54300 (1 page)
- 38500 (1 page)
- 38420 (1 page)
- 23220 Series (1 page)
- 35623 (1 page)
- 38300-38320 (1 page)
- 35200 (1 page)
- 38600-38620 (1 page)
- 93029 (3 pages)
- 35180 (1 page)
- 38950-38970 (2 pages)
- 35750-35780 (1 page)
- 93038 (2 pages)
- 38525 (3 pages)
- 29600 (1 page)
- 43500 Series (1 page)
- 38200-38220 (1 page)
- 38250-38270 (1 page)
- 93040 (3 pages)
- 38940 (1 page)
- 53200 (1 page)
- 93055 (2 pages)
- 93045 (3 pages)
- 81250-81290 (1 page)
- 26126 (1 page)
- 38955-38975 (2 pages)
- 26125 (1 page)
- 29700 (1 page)
- 93046 (2 pages)
- 38980 (2 pages)
- 35640-35650 (1 page)
- 35850-35860 (1 page)