Ingalls 35850-35860 - Manual

ING3585/3586
Copyright © 2001-04 Ingalls Engineering Co., Inc.
Inner
fender
crossbolt
Installation Instructions
1. Raise rear of vehicle and support vehicle on jack stands under body
so the tire just touches the ground. The tire/rim assembly may be
removed for easier access to the control arm.
2. Loosen the upper control arm to the spindle bolt. Loosen both inner
mounting cross bolts.
3. Remove all 4 inner fender bracket bolts.
4. Place the same number of spacers at each mounting bolt location.
The bracket range is ±1° and each spacer will give an additional ½°
of camber adjustment (see chart below). Use the existing OE bolts
(25mm lg) if one or two spacers are installed and use the new bolts
(40mm lg) if more than two spacers are installed. Do not install
more than four spacers.
5. Torque the inner fender bracket bolts to 35 lb.-ft.
6. Replace the tire/rim assembly if previously removed.
7. Lower the vehicle on to skid plates and adjust both cams equally (to
prevent twisting) to desired manufacturers specifications.
8. Hold the cam bolts in position, and torque the cam bolt locknuts to
35 lb.-ft.. Torque the crossbolt at the spindle arm mount to 50 lb.-
ft..
9. Check and set rear toe to specifications.
Install spacers
between mount
and fender well.
Important:
Place the same
number of spacers at
each mounting bolt
location per wheel.
Use new bolts if
using 3 or more
spacers.
Limited Warranty
Subject to Disclaimer. All Ingalls products are warranted against defects in materials and workmanship
for ninety (90) days from date of purchase. During the warranty period, Ingalls will repair, or at its
option replace at no charge, components that prove to be defective. The product must be returned,
shipping prepaid, to Ingalls facility. This limited warranty does not apply if the product is damaged by
accident or misuse. The foregoing warranty is in lieu of all other warranties expressed or implied
including but not limited to any implied warranty of merchantability, fitness, or adequacy for any
particular purpose or use Ingalls shall not be liable for any special, incidental or consequential damages
whether in contract, tort, or otherwise resulting from the use of or the inability to use the product.
WARRANTY DISCLAIMER
Use of this product in competition, or use on vehicles altered from original manufacturer's specifications
or settings, EXPRESSLY VOIDS WARRANTY. The user is urged to inspect for suspension binding or
interference when the product is used in these manners. However, due to the varying conditions and
manner of use which the priduct will be subjected to in such uses, Ingalls Engineering Co., Inc. makes
no warranties, either express or implied, including any warranty of merchantability or fitness for a
particular purpose for use in competition or with specifications or setting other than those specified by
the original manufacturer's specifications.
Adjustment Range Spacers Needed Bolts Used
-1° to +1° None OE
-½° to +1-½° 1 OE
0° to +2° 2 OE
+½° to +2-½° 3 New
+1° to +3° 4 New