Ingalls 35150 User Manual
Ingalls For the car
Installation Instructions
1.
Record and document initial alignment readings.
2.
Raise vehicle by the chassis and support.
3.
Remove wheel and alignment equipment.
4.
Remove upper strut bolt on GM J, N, and L body cars and
Eagle Premier/Medallion Remove lower strut bolt on
GM C and H body cars.
5.
Install the New cam bolt and washer in the same direction as
the original bolt.
6.
Locate and set pivoting hole at 12 o’clock.
7.
Drill out the strut using the pivoting hole as a guide hole.
8.
Insert a tapered 1/4" dowel pin or center punch in the hole.
9.
Install wheel and alignment instrument and compensate.
10. Loosen lower strut bolt on GM J, N, and L body cars and
Eagle Premier/Medallion.
Loosen upper strut bolt on GM C and H body cars
11. Rotate or slide thecam bolt until desired camber change is
achieved.
12. Tighten both strut bolts.
ING3515-72397
Copyright © 1997-04 Ingalls Engineering Co., Inc.
- 40000 Series (1 page)
- 93037 (3 pages)
- 93300 (2 pages)
- 93043 (3 pages)
- 39209 (2 pages)
- 35220 (1 page)
- 38930 (1 page)
- 93180-93181 (3 pages)
- 26128 (1 page)
- 93184 (2 pages)
- IK500033RDX (1 page)
- 35590-35622 (1 page)
- 54300 (1 page)
- 38500 (1 page)
- 38420 (1 page)
- 23220 Series (1 page)
- 35623 (1 page)
- 38300-38320 (1 page)
- 35200 (1 page)
- 38600-38620 (1 page)
- 93029 (3 pages)
- 35180 (1 page)
- 38950-38970 (2 pages)
- 35750-35780 (1 page)
- 93038 (2 pages)
- 38525 (3 pages)
- 29600 (1 page)
- 43500 Series (1 page)
- 38200-38220 (1 page)
- 38250-38270 (1 page)
- 93040 (3 pages)
- 38940 (1 page)
- 53200 (1 page)
- 93055 (2 pages)
- 93045 (3 pages)
- 81250-81290 (1 page)
- 26126 (1 page)
- 38955-38975 (2 pages)
- 26125 (1 page)
- 29700 (1 page)
- 93046 (2 pages)
- 38980 (2 pages)
- 35640-35650 (1 page)
- 35850-35860 (1 page)