Ingalls 38200-38220 - Manual

ING3822-11072011 Installation Instructions
1. Before starting alignment, complete inspection checklist. Determine the amount of
change needed.
2. Raise rear of vehicle and support with jack stands.
3. Remove wheel and tire assembly.
4. Remove OE arm by removing inner bolt and unbolting arm at the spindle.
5. Install adjustable arm. Add washer and spacer to spindle end of arm to position arm in
factory location (washer should be in between the arm and spacer). Torque spindle bolt
to 63-86 ft-lbs, torque inner nut to 50-70 ft-lbs.
6. Replace wheel and tire assembly.
7. Adjust toe to factory specifications by loosening jam nuts and turning built-in adjuster.
DO NOT exceed more than 3/4" of exposed threads on either side of end link.
8. After adjusting toe, tighten jam nuts and complete alignment.
Limited Warranty
Subject to Disclaimer. All Ingalls products are warranted against defects in materials and workmanship for
ninety (90) days from date of purchase. During the warranty period, Ingalls will repair, or at its option
replace at no charge, components that prove to be defective. The product must be returned, shipping pre-
paid, to Ingalls' facility. This limited warranty does not apply if the product is damaged by accident or
misuse. The foregoing warranty is in lieu of all other warranties expressed or implied including but not
limited to any implied warranty of merchantability, fitness, or adequacy for any particular purpose or use.
Ingalls shall not be liable for any special, incidental or consequential damages whether in contract, tort, or
otherwise resulting from the use of or the inability to use the product.
WARRANTY DISCLAIMER
Use of this product in competition, or use on vehicles altered from original manufacturer's specifications or
setting, EXPRESSLY VOIDS WARRANTY. The user is urged to inspect for suspension binding or
interference when the product is used in these manners. However, due to the varying conditions and
manner of use which the product will be subjected to in such uses, Ingalls Engineering Co., Inc. makes no
warranties, either expressed or implied, including any warranty of merchantability or fitness for a particular
purpose for use in competition or with specifications or setting other than those specified by the original
manufacturer's specifications.