Ingalls 29200 User Manual
Ingalls For the car
Installation Instructions
1. Support truck by lower control arms.
2. Remove the tire and wheel assembly to gain access to the
upper control arm mounting area.
3. Remove OEM control arm mounting bolts and washers.
NOTE: Replace one upper control arm bolt assembly at a time.
4. Install thrust washer on cam bolt so that it is in between
the mount and the cam washer.
5. Install camber/caster adjuster cam bolt.
6. Install a second thrust washer onto cam bolt.
7. Install cam washer, lock washer, and nut. Tighten slightly.
8. Repeat steps 3 thru 7 for other upper control arm bolts.
9. Adjust the camber by rotating the cams within the frame
mounting brackets, 3/8 ratcher may be used in the square
hole to rotate cams.
10. Torque the cam nuts to 80-100 ft. lbs.
11. Reinstall the wheel and road test.
ING292-100501
Copyright © 2001-04 Ingalls Engineering Co., Inc.
- 40000 Series (1 page)
- 93037 (3 pages)
- 93300 (2 pages)
- 93043 (3 pages)
- 39209 (2 pages)
- 35220 (1 page)
- 38930 (1 page)
- 93180-93181 (3 pages)
- 26128 (1 page)
- 93184 (2 pages)
- IK500033RDX (1 page)
- 35590-35622 (1 page)
- 35150 (1 page)
- 54300 (1 page)
- 38500 (1 page)
- 38420 (1 page)
- 23220 Series (1 page)
- 35623 (1 page)
- 38300-38320 (1 page)
- 35200 (1 page)
- 38600-38620 (1 page)
- 93029 (3 pages)
- 35180 (1 page)
- 38950-38970 (2 pages)
- 35750-35780 (1 page)
- 93038 (2 pages)
- 38525 (3 pages)
- 29600 (1 page)
- 43500 Series (1 page)
- 38200-38220 (1 page)
- 38250-38270 (1 page)
- 93040 (3 pages)
- 38940 (1 page)
- 53200 (1 page)
- 93055 (2 pages)
- 93045 (3 pages)
- 81250-81290 (1 page)
- 26126 (1 page)
- 38955-38975 (2 pages)
- 26125 (1 page)
- 29700 (1 page)
- 93046 (2 pages)
- 38980 (2 pages)
- 35640-35650 (1 page)
- 35850-35860 (1 page)