Ingalls 93184 - Manual (Page 2)

© Ingalls Engineering Co., Inc. ● 2011 Cherry Street, Suite 104 ● Louisville CO 80027
(800) 641-9795 ● (303) 665-7800 ● Fax: (303) 665-7810 ● www.ingallseng.com
5. Ensure that the round hole (one hole is round and the other is slotted) in the cross bar on the Power Stick is
towards the fender and install one of the OEM bolts removed in step one. Tighten so that it draws the cross bar
down flush to the engine mount making sure that the length of the Power Stick is correct. Hand tighten both jam
nuts then remove the Power Stick from the vehicle and tighten bolt jam nuts.
6. Reinstall the Power Stick again as described in steps 4 & 5. Install the remaining OEM bolt in the slotted end of
the cross bar and torque all 3 bolts to OEM specifications. Note: If your vehicle already has the Stiffy™ (P/N
93038), reinstall the Stiffy™ engine bracket over the Power Stick™ and torque all bolt to manufacturers
specifications.
Illustration 1 Illustration 2
Illustration 3
Limited Warranty
Subject to Disclaimer. All Ingalls products are warranted against defects in materials and workmanship for ninety (90) days from date of purchase. During the
warranty period, Ingalls will repair, or at its option replace at no charge, components that prove to be defective. The product must be returned, shipping prepaid,
to Ingalls facility. This limited warranty does not apply if the product is damaged by accident or misuse. The foregoing warranty is in lieu of all other warranties
expressed or implied including but not limited to any implied warranty of merchantability, fitness, or adequacy for any particular purpose or use. Ingalls shall not
be liable for any special, incidental or consequential damages whether in contract, tort, or otherwise resulting from the use or the inability to use the product.
Warranty Disclaimer
Use of this product in competition, or use on vehicles altered from original manufacturer’s specifications or settings, EXPRESSLY VOIDS WARRANTY. The
user is urged to inspect for suspension binding or interference when the product is used in these manners. However, due to the varying conditions and manner
of use which the product will be subjected to in such uses, Ingalls Engineering Co., Inc. makes no warranties, either express or implied, including any warranty of
merchantability or fitness for a particular purpose for use in competition or with specifications or settings other than those specified by the original manufacturer’s
specifications.
For more information on Ingalls products, visit us on the web at www.ingallseng.com