Peerless-AV ST680-AW - Installation - Manual (Page 9)

9 of 32 ISSUED: 09-30-11 SHEET #: 203-9051-1
For preset tilt angles use Increlok™ and for custom
tilt angle use ratchet handle.
INCRELOK™: The display can be locked into a
pre-set tilt position of -5°, 0°, 5°, 10° or 15°. Use
locator hole to fi nd tilt position hole and tilt display
to align holes. Tighten IncreLok™ tilt locking screws
on both tilt brackets to lock tilt as shown in detail 3.
Ratchet Handle: Loosen ratchet handle (refer to
step 3 for tension adjustment of handle). Push or
pull from top or bottom of display to adjust tilt as
shown in fi gure 4.1. The tilt can be adjusted to a
maximum of 15° forward or 5° backward.
Tension Adjustment of Ratchet Handle: Adjust
tension in tilt brackets (BB & CC) by rotating ratchet
handle. NOTE: If obstruction prevents ratchet
handle from rotating, pull handle out while turning
will allow handle to reposition without tightening.
Release and turn handle to tighten or loosen.
Mounting Display: Ratchet handle must be in the
up or down position or interference will occur while
hooking tilt brackets to wall plate (AA). Slowly hook
tilt brackets (BB & CC) onto wall plate (AA) and
swing display down as shown in fi g. 3.1. Tilt bracket
hooks must fully engage wall plate as shown in
detail 2. Using phillips screw driver or security allen
wrench (FF), turn safety/security screws on tilt
brackets (BB & CC) clockwise till screw tip securely
contacts wall plate as shown in cross section.
Display Adjustment: Display can be adjusted
horizontally by loosening safety/security screws
on tilt brackets (BB & CC) three full turns. Adjust
display as shown in fi gure 3.2. Tighten safety/
security screws on tilt brackets till screw tip securely
contacts wall plate as shown in cross section.
Removing Display: To remove display from mount,
loosen safety screws, swing display away from
mount, and lift display off of mount.
Mounting and Removing Flat Panel Display
DETAIL 3
fi g. 4.1
IncreLok™
TILT LOCKING
SCREW LOCATOR
HOLE
RATCHET
HANDLE
TILT
POSITION
HOLES
fi g. 3.2
Adjusting the Tilt Angle of the Flat Panel Display
• Always use an assistant or mechanical lifting
equipment to safely lift and position the fl at panel
display.
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fi ngers when pushing display
from the bottom.
WARNING
fi g. 3.1
RATCHET
HANDLE
AA
SAFETY/
SECURITY
SCREW
DETAIL 2
AA
CROSS SECTION
BB,CC
BB,CC
3
4