Peerless-AV ST680-AW - Installation - Manual (Page 8)

8 of 32 ISSUED: 09-30-11 SHEET #: 203-9051-1
Begin with the shortest length screw, hand thread through multi-washer and tilt bracket into display as shown
below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not over
tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
NOTE: If using M10 x 15mm penta-pin TM screws, tighten screws with Penta-pin TM driver (I).
Begin with longer length screw, hand thread through multi-washer, tilt bracket and spacer in that order into display
as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: If using M10 x 15mm penta-pin TM screws, tighten screws with Penta-pin TM driver (I).
For Flat Back Display
For Bump-out or Recessed Back Display
TILT BRACKET
(BB,CC)
DISPLAY
fi g. 2.1
SCREW
2-1
2-2
If you have any questions, please call Peerless customer care at 1-800-865-2112.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
MULTI-WASHER
DISPLAY
SCREW
TILT BRACKET
(BB,CC)
fi g. 2.2
SPACER
MULTI-WASHER