Peerless-AV SA771PU-AW - Installation - Manual (Page 11)

11 of 56 ISSUED: 03-09-12 SHEET #: 095-9386-2 03-26-12
Begin with the shortest length screw, hand thread
screw through multi-washer and screen brackets
(B) into screen as shown below. Screw must make
at least three full turns into the mounting hole and
fi t snug into place. Do not over tighten. If screw
cannot make three full turns into the screen, select
a longer length screw from the baffl ed fastener
pack. Repeat for remaining mounting holes, level
screen brackets and tighten screws.
NOTE: Spacers may not be used, depending upon
the type of screen.
Skip to step 3-6.
Begin with the longest length screw, hand thread
screw through multi-washer, screen brackets (B)
and spacer in that order into screen as shown
below. Screw must make at least three full turns
into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three
full turns into the screen, select a shorter length
screw from the baffl ed fastener pack. Repeat for
remaining mounting holes, level screen brackets
and tighten screws.
For Flat Back Screen
For Bump-out or Recessed Back Screen
3-4
3-5
SCREEN
MULTI-WASHER
SCREW
B
SCREEN
MULTI-WASHER
SPACER
B
SCREW
Center screen brackets horizontally and vertically
on back of screen. Tighten two 1/4-20 x 1.25"
screws. Reinstall four 1/4-20 x .6" screws using
5mm allen wrench (I) into appropriate fi xed-stop
position from chart on page 9. 3-6
1/4-20 x 1.25" SCREWS
1/4-20 x .6" SCREWS