Peerless-AV HP455 - Installation - Manual (Page 6)

ISSUED: 06-28-12 SHEET #: 125-9328-2 6 of 9
200 mm x 100 mm Hole Pattern 200 mm x 200 mm Hole Pattern
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not
tightly secured, damage may occur to screen or product may fail.
WARNING
Mounting using Large Hole Pattern
(300 mm x 300 mm or greater)....................Start page 6
Mounting using Small Hole Pattern (200 mm x 200 mm or less) .....................Skip to page 8
Mounting using Large Hole Pattern (300 mm x 300 mm or greater)
9
Fasten two vertical rails ( T) to lower horizontal rail (S) and upper horizontal rail (V) in 300 mm x 300 mm or 400 mm
x 400 mm hole patterns using four M5 x 10 mm socket pin Type-F screws ( E) as shown below.
400 mm x 400 mm Hole Pattern
T T
E
V
V
E
300 mm x 300 mm Hole Pattern
8
Press-in four tube caps ( D) into lower horizontal rail (S) and upper horizontal rail (V) as shown below.
D
S and V
S
S
NOTE: Rails must be square to one another. Use a flat surface as a guide when tightening.
NOTE: Vertical rails (T) must be perpendicular to lower horizontal rail (S) and upper horizontal rail (X). Use a flat
surface as guide while tightening.