Peerless-AV HP455 - Installation - Manual (Page 5)

ISSUED: 06-28-12 SHEET #: 125-9328-2 5 of 9
2
3
1
4
5
Align backer plate ( B) with threaded rods (M).
NOTE: Washer (F) must be centered.
FRONT OF
SCREEN
Detail 1
B
M
fig. 5.1
6
C
FRONT OF
SCREEN
F
Align base assembly (step 5) with supporting surface
and base ( C) pattern facing the front as shown in
Detail 1. Tighten four fender washers ( L) with four
lock nuts ( N) in the sequenced pattern shown in
Figure 6.1 with the 1/4 - 20 locknuts ( N) at minimum
flush with the bottom of the threaded rods ( M).
fig. 6.1
L
N
Mounting using Non-Security
Mounting using Security Slop Nuts (Optional)
Detail 4
TIGHTENING
SLOPE NUT (G)
G
5/8" OPEN BOX WRENCH
TIGHTENING
SLOPE NUT (G)
M
M
G
Detail 2
Detail 3
G
For added security replace two of
the washers and locknuts with slope
nuts.
Hand tighten slope nuts ( G) onto
two of the thread rods ( M) until
snug against bottom of table as
shown in Detail 2.
Thread another slope nut ( G)
upside-down, about two turns from
first slope nut ( G) as shown in
Detail 3.
Insert a 5/8
"
open box wrench
between both slope nuts ( G) and
tighten
as shown in detail 4.
7
BOTTOM OF DESK
BOTTOM OF DESK
NOTE: Avoid jamming both slope nuts (G) together,
doing so may make it difficult to remove slope nut
used for tightening.
After slope nut is secure remove bottom slope nut.
LEAVE SPACE
IN BETWEEN
SLOPE NUTS