Peerless-AV HP455 - Installation - Manual (Page 3)

ISSUED: 06-28-12 SHEET #: 125-9328-2 3 of 9
Turn base ( C) upside down to insert support tube (A),
and thrust washer ( F) as shown below.
A
C
F
fig. 3.1
2 3
Turn base ( C) upside down and insert four threaded
rods ( M) into base (C), as shown below.
NOTE: Threaded rods must fasten a minimum
of three turns.
M
C
fig. 2.1
• Wooden mounting surface requires a minimum of 3/4" thickness to hold screen securely.
WARNING
1
Use base backer plate ( B) as a template to mark location of holes. Drill four holes using a 17/64'' drill bit in a
square formation. Drill a 2" to 3" cord management hole In the center of the square formation.
B
SQUARE FORMATION
CORD MANAGEMENT
CUT-OUT FRONT OF SCREEN
BOTTOM VIEW