Ff ii – Peerless-AV WL-SR560M-200 - Installation User Manual

Page 17

17 of 19

ISSUED: 08-24-12 SHEET #: 180-9037-2 10-30-12

Close the top cover of the power module assembly
(BB), making sure that the power adapter cords run
underneath the cable opening as shown below.
Re-install the M5 x 10mm phillips screws.

Install the cable tie anchor (FF) onto the inside
back wall of the power enclosure (BB). Remove the
adhesive backing from the anchor and press into
place in the area shown.

Place the cords inside the cable management sheath
(II) by pushing the cables through the slit in the
sheath. NOTE: The sheath may need to be trimmed
to length before installing cords.

CABLE
OPENING

M5 x 10mm SCREWS

Plug extension cord (not included) into power adapter.

EXTENSION CORD

Plug the power cord from your display into the triple
tap grounded outlet as shown. Coil up the excess
cord and secure with a cable tie (GG), inserting it
through the cable tie anchor (FF) and around the
coiled cord.

DISPLAY POWER
CORD

TRIPLE TAP
GROUNDED OUTLET

HDMI-

OUT

Plug the component cable(s) from your display
(HDMI shown) into the wireless receiver.

COMPONENT
CABLE