Warning, Bb aa, Installing adapter brackets to universal plate – Peerless-AV WL-SR560M-200 - Installation User Manual

Page 12

12 of 19

ISSUED: 08-24-12 SHEET #: 180-9037-2 10-30-12

NOTE: "X" dimensions should be equal.

NOTE: "Y" dimensions should be equal.

Installing Adapter Brackets to Universal Plate

To prevent scratching the screen, set a cloth on a fl at, level surface that will support the weight of the screen. Place
screen face side down. Refer to screen manufacturers instructions or customer service, for removing any knobs,
base, cover, or screw(s) on the back of the screen to prepare mounting. These need to be removed to allow the
adapter brackets to be attached.

Position adapter brackets (F) over mounting holes on back of screen. Adjust the position of assemblies
(AA and BB) so that they are at least 32" apart. Make sure assemblies (AA and BB) are evenly spaced from the
adapter brackets. Tighten screws (I) to lock position of assemblies (AA and BB).

Select the small, medium, large or extra large screws from the baffl ed fastener pack then attach adapter brackets to
screen following fi gure 13.1.

NOTE: Top and bottom mounting holes must be used for attaching brackets. Verify that all holes are properly
aligned, and then tighten screws using a security allen wrench.

CENTER BRACKETS

VERTICALLY ON BACK

OF SCREEN

Notes:

• The number of fasteners used will vary,

depending upon the type of screen.

• Multi-washers and spacers may not be

used, depending upon the type of screen.

• Use the corresponding hole in the multi-

washer that matches your screw size as
shown.

MEDIUM HOLE FOR M5 SCREWS

SMALL HOLE FOR M4 SCREWS

LARGE HOLE FOR M6 SCREWS

MULTI-WASHER

• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can

cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly

secured, damage may occur to screen or product may fail.

WARNING

32" Min.