Peerless-AV WL-SR560M-200 - Installation - Manual (Page 11)

11 of 14 ISSUED: 11-14-11 SHEET #: 180-9007-1
NOTE: For mounting patterns smaller than VESA 400, use large enclosure mounting bracket (DD).
Loosely attach the enclosure mounting brackets (CC or DD) to the power module assembly (BB) with two
1/4-20 x 12 mm screws (I) and two 1/4-20 nuts (EE) as shown in fi g. 12.1. NOTE: The enclosure mounting
bracket can be installed with the inside notch facing downward if additional side-to-side adjustment is needed.
Attach the mounting brackets (CC or DD), open end of notch facing downward, to the adapter bracket (F) with two
1/4-20 x 12 mm screws (I) and two 1/4-20 nuts (EE) as shown in fi g. 12.2.
Adjust the position of the power module assembly (BB) to your desired location as shown in fi g. 12.2. Once in
position, tighten the four 1/4-20 x 12 mm screws (I) using 4mm allen wrench (N).
Wireless Receiver and Power Enclosure Installation
NOTE: For mounting patterns smaller than VESA 400, use large enclosure mounting bracket (DD).
NOTE: The Wireless Receiver Assembly (AA) and Power Module Assembly (BB) position can be interchanged
based on the display’s connector panel location. Install Wireless Receiver Assembly on the side closest to the
connector panel.
Loosely attach the enclosure mounting brackets (CC or DD) to the wireless receiver assembly (AA) with two
1/4-20 x 12 mm screws (I) and two 1/4-20 nuts (EE) as shown in fi g. 11.1. NOTE: The enclosure mounting bracket
can be installed with the inside notch facing downward if additional side-to-side adjustment is needed. Attach the
mounting brackets (CC or DD), open end of notch facing downward, to the adapter bracket (F) with two
1/4-20 x 12 mm screws (I) and two 1/4-20 nuts (EE) as shown in fi g. 11.2.
Adjust the position of the receiver assembly (AA) to your desired location as shown in fi g. 11.2. Once in position,
tighten the four 1/4-20 x 12 mm screws (I) using 4mm allen wrench (N).
11
fi g. 11.1
fi g. 11.2
EE
F
F
AA
I
INSIDE NOTCH
I
CC or
DD
AA
EE
INSIDE NOTCH
12
fi g. 12.1 fi g. 12.2
I
I
BB
BB
EE
EE
INSIDE NOTCH
CC or
DD