Peerless-AV WL-EPT650-200 - Installation - Manual (Page 9)

9 of 16 ISSUED: 08-24-12 SHEET #: 180-9033-2 10-30-12
Open the wireless receiver enclosure (G) and unplug the wireless receiver power cord from the wireless receiver.
Remove the wireless receiver and sub panel assembly as shown in fi g. 5.1. Loosely attach the small enclosure
mounting brackets (M) to the wireless receiver enclosure (G) with two 1/4-20 x 1/2 socket head screws (H) and
two 1/4-20 nuts (I) as shown in fi g. 5.2. NOTE: The enclosure mounting bracket can be installed with the inside
notch facing downward if additional side-to-side adjustment is needed. Position and tighten the four 1/4-20 x 1/2
socket head screws (H) using 4mm allen wrench (O). Press in two plastic plugs (N) into holes shown in fi gure
5.2.
5
Wireless Receiver Enclosure Installation
fi g. 5.1
fi g. 5.2
G
N
M I
H
WIRELESS
RECEIVER
SUB PANEL
ASSEMBLY
WIRELESS
RECEIVER
POWER CORD
INSIDE NOTCH
Attach the mounting brackets (M), open end of notch facing downward, to the left tilt bracket with two
1/4-20 x 1/2 socket head screws (H) and two 1/4-20 nuts (I) as shown in fi g. 6.1. Adjust the position of the
enclosure (G) to your desired location and tighten the four 1/4-20 x 1/2 socket head screws (H) using 4mm allen
wrench (O). 6
fi g. 6.1
B
I
G
H