Peerless-AV WL-EPT650-200 - Installation User Manual

Page 13

13 of 16

ISSUED: 08-24-12 SHEET #: 180-9033-2 10-30-12

Remove the tie from the IR receiver and insert the
end through the cord access hole in the bottom of the
enclosure as shown.

Position the IR receiver on the front of the display
within line of sight of your remote as shown. Remove
the adhesive backing from the IR receiver eye and
attach to the display. Coil up the excess cord near
the wireless receiver enclosure and secure with a
cable tie (J). Store excess cord inside enclosure.

IR RECIEVER

IR RECEIVER

Plug the wireless receiver power cord back into the
wireless receiver. Position the wireless receiver
into the enclosure as shown, then close and lock
enclosure door with key provided.
(Locking optional)

WIRELESS
RECEIVER POWER
CORD

Insert your component cable(s) (HDMI shown)
from your display through the cord access hole in
the bottom of the enclosure as shown and plug into
the wireless receiver. Coil up the excess cord and
secure with a cable tie (K). Store excess cord inside
enclosure.

COMPONENT
CABLE