Peerless-AV WL-EPT650-200 - Installation - Manual (Page 15)

15 of 16 ISSUED: 08-24-12 SHEET #: 180-9033-2 10-30-12
© 2012 Peerless Industries, Inc.
Peerless-AV® is a registered trademark of Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
fi g 17.2
SAFETY/
SECURITY
SCREW
CROSS SECTION
DETAIL 2
A
B,C
B,C
A
fi g 17.1
Mounting Display: Slowly hook tilt brackets (B,C)
onto wall plate (A) and swing display down as
shown in fi g. 17.1. Tilt bracket hooks must fully
engage wall plate as shown in detail 2. Using
the security allen wrench (F), turn safety/security
screws on tilt brackets (B,C) clockwise till screw
tip securely contacts wall plate as shown in cross
section.
Optional Security: Place a padlock with a shackle
dia. of 1/4" (6.35mm) (not supplied) through both
holes in tilt bracket (B or C) for added security.
Display Adjustment: Display can be adjusted
horizontally by loosening safety/security screws on
tilt brackets (B,C) three full turns. Adjust display as
shown in fi gure 17.2. Tighten safety/security screws
on tilt brackets till screw tip securely contacts wall
plate as shown in cross section.
Removing Display: To remove display from mount,
loosen safety screws, swing display away from
mount, and lift display off of mount.
Mounting and Removing Flat Panel Display
• Always use an assistant or mechanical lifting equipment
to safely lift and position the fl at panel display.
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fi ngers when pushing display from
the bottom.
WARNING
Plug extension cord into power source.
To complete the installation of your wireless mount, please refer to the HD Flow™ User's Manual and the HD
Flow™ Install Guide included.
17
18