Peerless-AV WL-EPT650-200 - Installation - Manual (Page 14)

14 of 16 ISSUED: 08-24-12 SHEET #: 180-9033-2 10-30-12
Place the IR receiver and component cords inside the cable management sheath (L) by pushing the cables through
the slit in the sheath. NOTE: The sheath may need to be trimmed to length before installing cords. 15
L
DETAIL 1
fi g 16.1
IncreLok™
TILT
LOCKING
SCREW LOCATOR
HOLE
TILT
POSITION
HOLES
NOTE: Choosing and setting tilt position to the maximum setting may be easier before placing display onto wall
mount.
INCRELOK ™ : The display can be locked into a pre-set tilt position of -5 ° , 0 ° , 5 ° , 10 ° or 15 ° . Use locator hole to
fi nd tilt position hole and tilt display to align holes. Tighten IncreLok™ tilt locking screws on both tilt brackets to
lock tilt as shown in detail 1.
Adjusting the Tilt Angle of the Flat Panel Display
16