Peerless-AV HT642-003 - Installation - Manual (Page 6)

6 of 8 ISSUED: 07-07-11 SHEET #: 125-9221-1
Using a stud finder, locate and mark the edges of the metal stud used in mounting this product. Use of an edge
to edge stud finder is highly recommended. Use a level to draw a level, vertical line down the center of the stud.
Level wall plate, and mark the center of the four mounting holes. Make sure that the mounting holes are on the stud
center line. Drill four 1/2" holes through drywall and metal studs. Note: It may be necessary to drill 5/32" pilot holes
prior to drilling 1/2" holes.
3
• Product must be mounted through drywall that has a minimum thickness of 1/2" and into metal studs, 26 gauge or
heavier.
• Make sure that the wall will safely support the combined load of the equipment and all attached hardware and
components.
• Make sure that togglers are anchored into the center of the stud. The use of an "edge to edge" stud finder is highly
recommended.
WARNING
Installation to Metal Stud
3-1
3-2
3-3
3-4
3-5
Rotate toggler ( H) clockwise to wedge it
against inside walls of metal stud.
Push into hole.
Pivot end of toggler ( H).
Slide plastic cap forward while pulling back
firmly on ring.
Break off excess.
H
1
2
3
4
5
fig. 1.3
drill
1/2"
hole
H
H
H
H