PowerWalker ATS - Manual (Page 2)

EN
1. Introduction
This ATS product is designed with two independent power inlets to supply power to the load from
a primary power source. Should primary power source fail, the secondary will automatically back
up the connected equipment without any interruption. The transfer time from one line to another
is seamless to the connected equipment. After switching to a secondary power source, the ATS can
also switch power back to the primary input when power to the primary input is restored.
Package contents:

ATS module
 User manual
 mounting brackets
2. Product Overview
Front View:

Power switch for input source A

Power switch for input source B

Circuit breaker for output 2

Circuit breaker for output 3

USB communication port

RS-232 communication port

Communication slot

Operation indicators (please refer to section 4 for the details)
Back View

Contact port (please refer to section 7 for the details)

Output receptacles “Output 3” (IEC 10A)

Output receptacles “Output 2” (IEC 10A)

Output receptacle “Output 1” (IEC 16A)

Input source A connector

Input source B connector