B&B Electronics 232BSS4 - Manual - Manual (Page 10)

6 Documentation Number 232BSS4-0812m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Port Configurations
The 232BSS4 provides a dedicated UART to all five ports. This allows
any port to be individually configured for baud rate, number of data bits,
parity, and hardware (RTS/CTS) handshaking. Configuration of all the
ports is done through the setup software.
Baud Rate:
Each port is configurable for the following baud rates:
1200
2400
4800
9600
19.2K
38.4K
57.6K
or 115.2 kbps
Data Bits:
Each port can be configured for Seven or Eight data bits.
Note: If the Master and Slaves are set up differently, the port set for
Seven data bits cannot transmit the eighth bit.
Parity:
Each port can be configured for Even, Odd, or No parity. Because
the Master port uses a slightly different UART, it is not capable of
receiving only seven bits, thus seven data bits with no parity is not
allowed on the Master port. All other configurations are possible.
Stop bits:
Each port uses 1 stop bit. This value is currently fixed and can not
be changed in the setup software.
Hardware(RTS/CTS) Handshaking:
Each port can be configured to hold data until its input handshake
line goes high. On the Master port, pin four (RTS) would have to be
held high by the host device in order for the 232BSS4 to send data. On
the Slaves, pin eight (CTS) needs to be held high by the Slave device
for the 232BSS4 to send data. The connected devices can prevent data
from being sent from the 232BSS4 by holding their corresponding
handshake lines low.