B&B Electronics 855-12260--63 - Manual - Manual (Page 14)

11
Configuring the McPC 10/100 (ISA Version)
Before installing, configure McPC 10/100 for desired features using the DIP
Switch located as shown below on the printed circuit board (PCB). The following
illustration shows the location of the DIP Switch as well as its default settings.
Consult the chart below for the function of each switch.
The table below shows the DIP Switch settings for McPC 10/100:
Feature Switch # Function Defaul
t
LFD 5 Link Fault Detection (Available in Force modes only) OFF
AN 6
Auto Negotiation Mode (Valid only when Force
mode is disabled)
ON
Force 7
Force Mode – Forces the converter to operate at 10
or 100 Mbps as determined by switch 8
OFF
10/100 8
Valid only when switch 7 is ON.
When ON, the converter operates at 10 Mbps.
When OFF, the converter operates at 100 Mpbs. 8
is only valid in Force Mode, i.e. when switch 7 is ON
OFF
NOTE
Switch #'s 1 – 4 are factory configured – DO NOT CHANGE